1. How to cutThe plant grows very fast, and the leaves grow very lush and overlap a lot, making the entire plant shape messy and affecting its ornamental value. If the leaves overlap too much, some leaves will not be able to access sunlight, will not be able to synthesize chlorophyll, and will begin to turn yellow. When pruning, bad leaves and old leaves need to be pruned first to avoid affecting other leaves. Then you need to cut off the denser leaves in the middle, because they basically have no function, and cutting them off will reduce the nutrient burden. Try not to cut the leaves near the outside or the top, so that they can fully utilize photosynthesis and provide continuous support for the entire plant. The overall form also needs to be considered and the whole cannot be ignored. 2. Best timeThe best time to do the pruning is in spring, March or April, or later. During this stage, the branches sprout very quickly, and after removing these leaves, they can grow out and recover quickly. 3. Maintenance after cuttingAfter completion, protect the wound from rain or water to avoid rot. At the same time, as the number of leaves decreases, the amount of watering should also be reduced. |
<<: What fertilizer should I use for the small leaves of the green radish and the yellow leaves?
1. Long flowering and fruiting period 1. After be...
Pruning methods There are many ways to prune boug...
1. Set up support If you want the Monstera to gro...
1. Reduce light Reason: Although it likes light, ...
Coriander is the most important seasoning vegetab...
Natural water is divided into hard water and soft...
1. Soil It is best to choose loose, breathable an...
In fact, when it comes to flower care and disease...
1. Is it possible? When it comes to maintenance, ...
1. Withering If we accidentally kill it, it will ...
Beginners buy seedlings like this, and gradually ...
What flowers are placed in the East The east is t...
1. How many plants can be grown in one pot? Gener...
Watermelon is a common fruit in daily life and is...
Ficus microcarpa What should I do if rust spots a...