How to graft loquat trees

1. Grafting method

1. Sawing the anvil: The position of the grafted branch should be one meter high. Choose a tree with only 2-3 branches. Use a saw to cut off the branch you are going to use at 15-20 cm from it. Other thinner branches can be cut off. The wound should be made relatively flat, and the incision should be slightly inclined.

2. Cutting the anvil: Use a knife to make a small slanted cut in a smoother area on the tree's skin. Don't cut too deep, just to the point where the bark touches the wood inside.

3. Cut the scion: Use a knife to cut a 45º slope on the bottom of the selected scion. The slope should be 1.5 cm long, leaving two small holes on the other side of the scion. The excess part can be cut off.

4. Bandaging: Connect the scion to the interface, and then tie it tightly with the prepared tools. This will not only make it extremely strong, but also speed up the recovery of the wound and increase the success rate of grafting.

2. Precautions

1. Both scissors and saws are relatively sharp, so be careful not to hurt yourself when operating them.

2. The cuts made by scissors and saws should be made relatively flat, not uneven, and the incision must have some inclination.