How to make hyacinth plastic bottle

1. Material preparation

A small knife, a pair of scissors, a 600 ml bottle of mineral water, and a bottle of disinfectant.

You can choose a mineral water bottle that is shorter, has a larger bottom area and is relatively hard. Avoid those that are thin and easily deformed.

2. Practice

1. First, use a knife to cut a hole in the bottle 10 cm away from the bottom, and then use scissors to cut it horizontally.

2. Process the bottle mouth. If the bottle mouth is relatively large, you can throw away the bottle cap. If the bottle mouth is small and not enough for all the roots to pass through, you need to cut it in the middle so that the roots can pass through the hole in the middle, and then throw away the side with the flat cap.

3. Prepare the disinfectant according to the instructions and place the two bottles of mineral water in it for disinfection.

4. Take out the bottle and place it in a ventilated place to dry.

5. Invert the top half of the bottle and place it into the bottom half, making sure it does not tip over the bottom of the bottle. A simple planting bottle is ready.

3. Usage

1. Before planting, you need to place the sealed bulb upside down into the upper bottle, and then place the upper bottle into the lower bottle. Place it on a table and see if the bottle can hold up without falling over.

2. If there is no problem, we need to add water to the lower bottle, approximately to the height of the upper bottle mouth in the lower bottle.

3. Place the upper bottle into the lower bottle, and then place the bulb with the roots facing down into the bottle.