How to propagate eagle claw flower

How to propagate eagle claw flower

1. Sowing method

The seeds of eagle claw flower are relatively small. For seeds that are difficult to collect by hand, we can use a toothpick or one end of a stick-shaped tool to wet it in water, then collect these tiny seeds and stick them on the surface of the culture matrix, and then cover it with about 1 cm of matrix, and then put the flowerpot with seeds into the water. The water depth should be about two-thirds of the height of the pot; for larger seeds, you can directly sow the seeds into the culture matrix at a spacing of 3x5 cm, cover them with a layer of matrix after sowing, and then use a sprayer or fine-hole shower to wet the matrix layer, and then water it when the soil in the pot is a little dry. When watering, you should be careful to control the intensity to prevent the seeds from being washed out of the substrate.

2. Cutting method

In late spring and early autumn, the climatic conditions are more suitable. At this time, you can choose relatively tender new branches for cuttings. If you want to propagate in early spring, you can also use old branches from previous years for cuttings. When taking cuttings, you can use peat soil, river sand and other materials as the cutting medium, and if conditions permit, you can prepare nutrient soil. Before cuttings, it is best to disinfect the cutting medium first. Medium-coarse river sand can also be used for cuttings after being rinsed clean. However, river sand in saline-alkali areas cannot be used because of its high salinity, and sea sand cannot be used because of its high salt content.

3. Layering method

Eagle claw flower can also be propagated by pressing branches. Choose relatively strong branches and peel off the skin about 15-30 cm from the top of the branch. The peeled wound is expected to be about one centimeter wide. Then select a piece of film that is 10-20 cm long and 5-8 cm wide, put some wet substrate in it, and then bandage the ring-barked area like bandaging a wound. Finally, tie the upper and lower ends of the film with a rope, and bulge in the middle. It will take about a month for the roots to grow. After that, cut off the branches together with the roots, and it will become a new plant.

<<:  Management of the flowering period of Rhododendron

>>:  Steps for planting crystal candles

Recommend

What to do if the leaves of azalea turn black

1. Reduce watering Reason: If you water too much ...

Is it easy to grow hydroponically? Hydroponics care methods and precautions

Is it easy to grow asparagus fern in water? Aspar...

What are the flowers suitable for spring cuttings?

Fuchsia Spring is a good time to take cuttings of...

Peony propagation method, peony division propagation

1. Planting After the peony seeds are mature, the...

How to make bonsai with osmanthus

Bonsai Making Source The materials for osmanthus ...

Can I grow peach trees at home?

Can I grow peach trees at home? The peach tree ca...

How to take care of the newly bought petals

1. Water Catharanthus pomatia is one of the easie...

Cultivation methods and precautions of Schefflera

1. Breeding methods 1. Soil: Slightly acidic soil...

Does Rieger Begonia prefer shade or sun?

Does Rieger Begonia prefer shade or sun? Begonia ...

What to do if the leaves of hydroponic lucky bamboo turn yellow

The leaves of the newly bought lucky bamboo are t...

How to build a frame for the fragrant vine

1. Prepare the sticks To build a rack for plants,...

Key points of oriental flower arrangement

The proportions of the branches and the flowerpot...

Pineapple cultivation method

1. Unified cultivation 1. If you want to plant an...