The flower pot made of cement by a flower friend for 1 yuan is more beautiful than the flower pot I bought for 50 yuan

DIY Swan Flower Pot

Production steps:

1. Prepare a relatively large plastic bottle, lay it flat and cut one side, then fill it with soil. Finally, bend a thick iron wire into an S shape and insert one end into the mouth of the plastic bottle.

2. Cover the outside of the plastic bottle with cement, and also apply cement where the bottle mouth meets the wire. (To create the look of a white swan, you can mix cement and plaster to make white cement)

3. Find two wire meshes that are longer than the plastic bottle, and stick them tightly along the outside of the plastic bottle to serve as the two wings of the swan.

4. Then use cement to completely cover the wire mesh.

5. For the thick wire, you can wrap it with gauze or white cloth in circles, and then apply cement on the cloth.

6. It will only take a few minutes to make a swan flower pot. Don’t forget to drill holes in the bottom, otherwise the flower pot will not be waterproof.

7. Finally, don’t forget to draw eyes and a mouth for the swan, and then you can plant flowers directly in the swan flower pot!

Homemade irregular flower pots

Production steps:

1. Prepare the necessary materials: an irregularly shaped fruit plate, a plastic cup and mixed cement. First clean the inside of the irregular plate, then apply a layer of glue on the inner wall of the plate.

2. Apply a layer of glue around the outer wall of the prepared plastic cup.

3. Place the mixed cement in an irregular basin until the entire basin is filled.

4. Press the plastic cup down in the middle of the basin filled with cement, but do not press it to the bottom. Let the top of the plastic bottle be slightly higher than the cement surface. Turn the basin over and poke a few small holes at the bottom to allow water and air to pass through.

5. Then place it in the sun and wait until the cement is completely dry. Then remove the plastic bottle and the outer pot. A beautiful irregular cement flower pot is ready.

6. Flower lovers can also use this method to make flower pots of any shapes they want, and the flowers they grow will look very beautiful!

Homemade Cake Flower Pots

Production steps:

1. Prepare a paper box, cut it into the shape shown along the corners of the box, then prop it up and use tape to fold it in half.

2. Fold the paper box into a three-dimensional triangular prism, and then slowly pour the mixed cement into the paper box.

3. Find a plastic bowl that is smaller than the paper box and press it down in the center of the box filled with cement. Then use something like chopsticks to poke a few small holes in the bottom to use as drainage holes.

4. Then expose it to the sun for a while to allow the cement to fully solidify. After the cement is completely dry, you can take out the plastic bowl and paper box, and a small cake flower pot is ready.

5. If you think the flower pot made in this way is not beautiful, you can also paint the finished flower pot with your favorite color!

DIY Leaf Flower Pots

Steps:

1. If you want to make a leaf flower pot, the materials you need are: cement, large leaves, dye and soil.

2. Spread out the soil layer, then spread the leaves flat on the soil, press them slightly, and try to leave no gaps between the leaves and the soil.

3. Pour the mixed cement on the leaves until the entire leaf is covered, then poke a few small holes at the bottom to allow it to pass through water and air.

4. After the cement is completely dry, peel the leaves off the cement and a cement flower pot is ready.

5. If you think the color of cement is ugly, you can use dye to dye it into any shape you like.

In addition to the cement flower pots introduced by Huahua above, there are actually many beautiful flower pots that can be made with the simplest cement!