You don’t need to buy rooting agents, you can do it at home in just 2 minutes, and the rooting rate is 100%!

White sugar solution

The white sugar solution rooting agent is simple to make and has obvious effects. The rooting rate of plants such as camellia and azalea, which are difficult to root, can reach over 90%. Everyone who has used it says it is good.

Preparation method:

1. First, use hot water to dissolve the sugar, the ratio of sugar to water is 1:10.

2. After the solution cools down, insert the branches that have been cut in advance into the solution and wait for about 2 to 3 minutes.

3. Take out the branches, wash the cut surface with clean water, cut a partial incision with a knife, and then you can directly plant them.

4. Place it in an environment of about 15℃ and it will take root soon.

Rice vinegar solution

Rice vinegar solution can make plants take root, mainly because rice vinegar contains acetic acid and other nutrients needed by plants. Rice vinegar solution rooting agent can be easily prepared and has significant effects.

Preparation method:

1. Mix rice vinegar and boiled water in a ratio of 1:100.

2. Place the branches to be cut into the solution and leave it for about half an hour.

3. After taking out the branches, dry them in the shade and then you can start grafting.

4. As long as it is warm enough, it will take root quickly.

Willow Extract

Willow trees can be seen everywhere in our lives, but did you know that willow bark contains a large amount of growth hormone? It is precisely because of the presence of this growth hormone that willow extract becomes an effective rooting agent.

Preparation method:

1. Cut 10 willow branches about 10 cm long.

2. Soak the willow twigs in water for 24 hours.

3. Place the branches to be cut into the leached solution, soak for 6 to 8 hours, then dry them and they can be cut directly.

4. If you want the branches to take root quickly, remember to put them in an environment of about 15℃.

Vitamin B12 Solution

The solution obtained by dissolving vitamin B12 in water can not only promote rooting, but also effectively promote wound healing.

Preparation method:

1. Crush 1 vitamin B12 tablet and add 50 times water and mix well.

2. Soak the branches to be cut into the solution for about 10 minutes.

3. Take out and dry in the shade, then directly plant the cuttings into the prepared nutrient soil.

4. As long as the temperature is right, it will take root soon.

Aspirin solution

Aspirin is a common medicine in daily life. The salicylic acid contained in aspirin enables the aspirin solution to quickly promote the rooting of plants.

Preparation method:

1. Cut the aspirin into two pieces, crush half of it, and add 100 times of clean water.

2. Soak the branches to be cut into the solution for about 5 minutes.

3. Take out the branches and dry them before cutting.

4. If you want it to take root quickly, the ambient temperature must be warm enough, around 15°C.

This is the end of the introduction on how to make your own rooting agent.

Have you learned it?

Come and practice it now!