How to grow Oxalis sorrel so that it will overflow the pot?

Oxalis is a small bulbous flower . The bulb is very small, about the size of a soybean. 5 to 10 plants can be planted in a flowerpot. Water it and place it on the balcony. It will germinate in three to five days. Many people like to grow this plant, so how can you grow Oxalis so that it will bloom out of the pot? Let’s take a look below.

1. Preparation

1. Soil selection

Oxalis likes to grow in well-drained soil rich in organic matter. Choose well-drained soil rich in organic matter as the planting medium. If you use garden soil for planting, you need to improve it into well-drained garden soil. You can add some leaf mold and river sand to the garden soil to increase drainage and air permeability.

2. Container selection

Choosing a suitable container can ensure the growth space and root development of Oxalis. It is recommended to choose a flower pot with a larger diameter and moderate depth, such as a ceramic pot or plastic pot of about 10 cm. If you choose to make your own flower pot, make sure there are drainage holes at the bottom of the pot.

3. Planting time

The planting time of Oxalis can be chosen in spring or autumn, and the specific time depends on the local weather conditions. The climate in spring and autumn is suitable, which is conducive to the growth of Oxalis.

2. Breeding Methods

There are two main methods of propagation of Oxalis: seed propagation and division propagation.

1. Seed propagation

Oxalis seeds are relatively small and require careful handling before sowing. First, soak the seeds in warm water at about 60°C, stir until the water cools down, and continue soaking for 2 hours. Then take out the seeds, dry the surface moisture, and then you can sow them. The sowing method can be spot sowing or broadcast sowing. The thickness of the soil should be about 2 times the diameter of the seeds. Keep the temperature at around 20℃ and the seeds will germinate in about 7 days.

2. Division propagation

Division propagation is one of the commonly used propagation methods of Oxalis. In spring or autumn, pour the mother plant out of the pot, shake off the soil, and cut its root parts with a sharp knife. After cutting, you can properly trim the old roots and diseased roots, and then plant them. Propagation by division can promote the germination of new shoots and flowering of Oxalis.

3. Planting Method

1. Planting density

When planting Oxalis, you need to pay attention to the density. Too dense a planting will cause the plants to grow slowly, while too sparse a planting will cause the plants to compete with each other for nutrients. It is generally advisable to plant 3-5 plants per pot .

2. Planting method

Plant the treated plants in pots, being careful not to bury them too deep. After planting, the soil needs to be lightly compacted so that the roots are firmly integrated with the soil. Then water thoroughly to allow full contact between the soil and the roots.

4. Maintenance and management

1. Watering management

Oxalis prefers a moist environment, but excessive water can cause the plant's roots to rot. Therefore, the amount of watering needs to be controlled according to climate and soil conditions. In spring and autumn, water it every 3-5 days; in summer, water it once in the morning and evening; in winter, water it once every 5-7 days. When watering, be careful to avoid water accumulation.

2. Fertilization management

Oxalis loves fertilizer , but too much fertilizer can cause the plant to suffer from root burn. Therefore, it is necessary to apply fertilizer reasonably according to the growth conditions. During the growing season, liquid fertilizer can be applied every 7-10 days; in winter, liquid fertilizer can be applied every 10-15 days. When applying fertilizer, be careful to avoid applying it near the roots of the plant.

3. Lighting management

Oxalis prefers an environment with plenty of sunlight. Adequate light can ensure that the plant grows healthily and blooms profusely. But you need to avoid exposure to the sun. During the maintenance process, appropriate shade is needed, which can block 50%-80% of the sunlight.

That’s it