How to propagate ash trees

How to propagate ash trees

Seed propagation

This method is more complicated to operate. Friends who are willing to try can follow the elements I mentioned. First, you need to collect seeds. Their seeds generally mature in September and October. At this time, choose healthier plants and pick them in time when the samaras turn yellow and the seed kernels have begun to harden. After the seeds are processed, they can be germinated.

Because seeds have a long dormancy period, germination is also very important. At this time, you can choose a location that is sheltered from the wind and facing the sun to dig a trench below the permafrost layer, but also ensure that it is above the underground water level. The width is about 80cm, and the length should be enough for planting seeds. Then spread a layer of wet sand about ten centimeters thick underneath. Then you can put the seeds into the ditch and mix them thoroughly with the wet sand.

A layer of wet sand should be added about 10 cm from the ground, and finally covered with soil. This process takes about two or three months. After that, you can sow and maintain the plants normally. One thing to remind you at this time is that if there is drought in early spring, you must replenish water in time, otherwise the soil will become hardened and no buds will sprout.

Cutting propagation

Everyone must be familiar with this method. This method is relatively simple. It is recommended that you choose this method if conditions permit. First, you need to choose good branches. Each section should not exceed 20cm, and the lower end should be cut at an angle. Try to use a sharper knife so as not to damage the remaining branches and bark. After disinfection, you can soak them in rooting solution to help them take root.

Before planting, you need to prepare the land for cultivating them and add basic fertilizer. Organic fertilizer is best. After covering the film, the cuttings are completed, but the later management cannot be ignored. Properly shading them from the sunlight can increase their survival rate.

<<:  The breeding method of Rhododendron serrata

>>:  How to breed Huang Qiuying

Recommend

How to trim copper coin grass

1. Leaf cutting The first thing we need to do is ...

When and how to prune apple trees

Apple cultivation has a long history and has dive...

Is June Snow suitable for a deep or shallow pot?

Is June Snow suitable for a deep or shallow pot? ...

How to prune elm trees

Principles of elm tree pruning The main purpose o...

What to do if the leaves of hydroponic copper coin grass turn yellow

1. Water Unclean water is a big reason, because o...

How to prune Phoenix bamboo

Pruning time of Phoenix bamboo Phoenix bamboo can...

How to prune large-leaf begonia (pruning time and method)

Big Leaf Begonia Pruning Time The time for prunin...

Asparagus's growing environment and local conditions

Asparagus Growing Environment and Conditions The ...

How long is the growth cycle of Dendrobium candidum?

Dendrobium officinale growth cycle The growth cyc...

Cultivation method of red leaf cordyline

Cultivation method of red leaf cordyline temperat...

How to solve the problem of yellow leaves of asparagus fern in winter

Sunbathing Asparagus fern is a semi-shade plant. ...